EasyManua.ls Logo

Sharp AL-1000

Sharp AL-1000
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DGB
3–13
1. Press the exposure mode selector
key to select the photo (
) mode.
The automatic exposure level can be adjusted to suit
your copying needs.
AUTOMATIC EXPOSURE ADJUSTMENT
AUTOMATISCHE BELICHTUNGSKORREKTUR
2. Press and hold down the exposure
mode selector key for approximately
5 seconds.
The photo (
) indicator will go out
and the AUTO indicator will begin to
blink. One or two exposure indicators
corresponding to the automatic expo-
sure level which has been selected
will light up.
3. Press the light (
{
) or dark (
}
) key to
lighten or darken the automatic expo-
sure level as desired.
If exposure level 2 is selected, the two
left-handmost indicators for that level
will light up simultaneously. Also, if
level 4 is selected, the two right-hand-
most indicators for that level will light
up simultaneously.
4. Press the exposure selector key. The
AUTO indicator will stop blinking and
light up steadily.
This automatic exposure lev-
el will remain in effect until you
change it again by this proce-
dure.
1. Die Wahltaste für den Belichtungs-
modus drücken und den Photo-Mo-
dus (
) wählen.
Die automatische Belichtungskorrektur kann Ihren
Kopieranforderungen gemäß eingestellt werden.
2. Die Wahltaste für den Belichtungs-
modus etwa fünf Sekunden lang ge-
drückt halten. Die Photo-Anzeige
(
) erlischt, und die AUTO-Anzeige
beginnt zu blinken. Eine oder zwei der
Belichtungsanzeigen leuchten auf, je
nach der gewählten Einstellung der
Belichtungsautomatik.
3. Die Taste Hell (
{
) oder Dunkel (
}
)
drücken, um die gewünschte Belich-
tungsautomatik einzustellen.
Wurde die Belichtungsstärke 2 ge-
wählt, leuchten die beiden linken äu-
ßeren Anzeigelämpchen gleichzeitig
auf. Bei Auswahl von Belichtungs-
stärke 4 leuchten die beiden rechten
äußeren Anzeigelämpchen gleichzei-
tig auf.
4. Die Wahltaste für den Belichtungs-
modus drücken. Die AUTO-Anzeige
blinkt nun nicht mehr, sondern leuch-
tet ständig.
Diese Einstellung der auto-
matischen Belichtung bleibt so
lange bestehen, bis sie durch
die oben genannten Schritte
erneut verändert wird.
PUMA_SPF_NON_EU_3.p65 09/11/98, 10:5113
Downloaded from: http://www.usersmanualguide.com/

Other manuals for Sharp AL-1000

Related product manuals