Sharp Aquos LC-13E1E - Page 37

35
Useful Features (Continued)
AV Connections (Continued)
[2] For programmes
• The influence of the AV control voltage and of fast blank at programme positions from 1 to 199
can be set.
• When connecting a video device to the AV1 terminal, you need to adjust the decoder programme
settings.
1 Perform steps 1 and 2 in
[1] AV1/AV2 to display the “AV
connections” screen.
2 Press ]/[ to select “For
programmes”, and then press OK
to display the “For programmes”
screen.
3 Press ]/[ to select the “AV
control voltage” or “RGB on-
screen display”.
4 Press </> to select “yes” or “no”.
Note:
• If the item concerned is set to “yes”,
the appropriate picture is through-
connected at all programme
positions from 1 to 199 when a
control voltage/an RGB signal is
applied.
5 Press ]/[ to select “For decoder
connected to AV1”, and then
press OK to display the decoder
programme selection screen.
6 Press ]/[ and/or </> to select
the programme for the decoder,
and then press OK. Repeat the
same procedure if you want to
specify other decoder
programmes.
7 Press MENU to return to the “For
programmes” screen.
8 Press ]/[ to select “Sound from
AV1”, and then press </> to
select the desired sound source.
9 Press END to exit.
E
CH
TV/VIDEO
REVEAL
HOLD
END
M
MENUSOUND
SUBTITLE
OK
SUBPAGE
TEXT
ROTATE
BRIGHT
T
END
]/[
</>
OK
OK
Back
M
End
E
For programmes
AV control voltage
[
no
]
RGB on-screen display
[
no
]
For decoder connected to AV1
Sound from AV1
[
Dec .
]
OK
Back
M
End
E
For programmes
AV control voltage
[
no
]
RGB on-screen display
[
no
]
For decoder connected to AV1
Sound from AV1
[
Dec .
]
MENU
OK
Back
M
End
E
AV connections
AV1
AV2
(
Y/C
)
AV2
(
CVBS
)
For programmes
OK
Back
M
End
E
For programmes
AV control voltage
[
no
]
RGB on-screen display
[
no
]
For decoder connected to AV1
Sound from AV1
[
Dec .
]
0
OK
Back
M
End
E
0
0
0
0
0
0
0
0
0
0
0
For decoder connected to AV1
8 E 9 16 E54
1 S 6 9 E1 17 E56
2 S 8 1 E11 18 E57
3 S1 11 E36 19
4 S11 12 E37 2
5 E 3 13 E38 21
6 E 5 14 E5 22
7 E 6 15 E53 23