29
Repeat steps 1 to 3 in Monochrome.
1
Film Mode
Automatically detects a fi lm-based source (originally
encoded at 24/25 frames/second, depending on the
vertical frequency), analyses it then recreates each still
fi lm frame for high-defi nition picture quality.
Press
a
/
b
to select “Film Mode”, and then
press ENTER.
2
Press
c
/
d
to select “On”, and then press
ENTER.
3
NOTE
• Film Mode is not selectable depending on the input signal
type.
Basic adjustment settings (Analogue/Digital)
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Picture”.
2
Press
a
/
b
to select “Advanced”, and then
press ENTER.
3
Monochrome
For viewing images in monochrome.
Press
a
/
b
to select “Monochrome”, and then
press ENTER.
4
Press
c
/
d
to select “On”, and then press
ENTER.
5
Range of OPC
The brightness level range of the OPC sensor’s
automatic adjustments can be set according to your
preferences. The adjustment range of the OPC sensor
can be set to a maximum of +16 and a minimum of
-16.
Repeat steps 1 to 3 in Monochrome.
1
Press
a
/
b
to select “Range of OPC”, and
then press ENTER.
2
Press
a
/
b
to select “Max.” or “Min.”, and
then adjust the item to the desired position.
3
Selected item
Max.
Min.
Description
-15 through +16
-16 through +15
NOTE
• This function is available only when the OPC setting is set
to On.
• The maximum setting cannot be set to a smaller number
than the minimum setting.
• The minimum setting cannot be set to a bigger number
than the maximum setting.
• The maximum and minimum settings cannot be set to the
same number.
• Depending on the brightness of the surrounding light, the
OPC sensor might not operate if the adjustment range is
small.
42PD7X_en_e.indd 2942PD7X_en_e.indd 29 2007/01/12 15:47:342007/01/12 15:47:34
To Next Page
Loading...
