QUICK REFERENCE
1 Attach your antenna to the back of the television.
(See page 9.)
2 Connect the AC plug for the television into the AC
outlet.
Use the remote control unit by pointing it towards the
remote control sensor on the ]V, Objects between the
remote control unit and the remote control sensor may
prevent proper operation.
- Place the TV close to the AC outlet, and keep the power
plug within reach.
- TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH UN-INSULATED PARTS OF ANY CABLES
WITH THE AC CORD CONNECTED.
3 When turning on the ]V for the first time, press
POWER on the television,
O
8
8
8
8
8
m
A
=POWER
4. Insert the batteries into the remote control unit. (See
page 9.)
- Speakers cannot be detached from the TV.
• The TV angle cannot be adjusted.
Remote control sensor
,'_ 7"-f '.....
-/ /_\ / 1/ (b m)
\ .,-.-----_/v'30_
_-0_*
* The angle is 8' when the stand is attached.
[] Cautions regarding the remote control unit
Do not expose the remote control unk to shock. In addition,
do not expose the remote control unk to liquids, and do not
place in an area wkh high humidity.
Do not install or place the remote control unit under direct
sunlight. The heat may cause deformation of the remote
control unit.
The remote control unk may not work properly if the remote
control sensor on the TV is under direct sunlight or strong
lighting, in such cases, change the angle of the lighting
or the TV, or operate the remote control unk closer to the
remote control sensor.
IMPORTANT:
IFTHE UNIT DOES NOT POWER ON _UNPLUG THE
TELEVISION FROM THE OUTLET AND REPEAT THE
INSTALLATION STEPS.
IFYOU STILL ENCOUNTER NO POWER, PLEASE CONTACT
US AT 1-800-BE-SHARP.
Q-8
To Next Page
Loading...
