Connecting to E×ternal Equipment
Refer to page 48 for a list of PC signals compatible with the ]V,
[] When using HDMI cable (iNPUT 1, 2, 3 or 4):
HDMI-certified cane
_ m
iiiii!iiiiii!iiiiiiiiiiiiiiiiiiiiiiiii!!ii
ii/iiiiiiiliiiiiiiiiiiiiiili_!i
ii iiiiiiiiiiiiii:
!i
- Depending on the board, only video signals may be output. In this case, in addition to connecting an HDMbcertified cable
to the INPUT 1, 2, 3 or 4 terminal, connect a G 3.5 mm stereo mini jack cable to the AUDIO PC/HDMI terminal and set
"Audio Select" to "HDMl+Analog". (See page 28.)
- The HDMI terminals only support digital signal.
[] When using DVI-HDMI conversion cable (INPUT 1, 2, 3 or 4):
_ _.[ _ _V'- _ conversion cable
Q 3.5 mm stereo mini jack cable
- When using a DVbHDMI conversion cable, you should make an analog audio connection. Inthis case, in addition to
connecting a DVI-HDMI conversion cable to the iNPUT 1, 2, 3 or 4 terminal, connect a © 3.5 mm stereo mini jack cable
to the AUDIO PC/HDMI terminal and set "Audio Select" to "HDMl+Analog". (See page 28.)
[] When using analog RGB cable (PC IN):
Ana,ogRGBcable
- When using an analog RGB cable, input the audio signal to the AUDIO PC/HDMI terminal of PC iN.
- When connecting a PC to the PC IN, set "Audio Select" to "Video+Audio". (See page 28.)
Q- 16
To Next Page
Loading...
