Using the Internet
1 Press MENU to display the MENU screen, and then
press 4/_ to select "initial Setup",
2 Press A/T to select "lntemet Setup", and then
press ENTER,
3 Press A/T to select "Network Setup",and then press
ENTER if "interactive Service" is selected "YES",
4 Press 4/1_ to select "Country"
5 Press _/1_ to select "US" or "Canada"or "Mexico"
at Country,
• Select different country item,the language will
synchronously change at Smart Central,
Connect to the IM with the following settings made for
IP on the PC.
TCP/IP
Set the IP address on the IM menu
None (Do not select Telnet or SSH)
Set a pot1 number on the IM menu
(Control pod)
When you set your ID and password on the IM menu,
you need to enter them as soon as you connect to the
TM.
1 Press MENU to displaythe MENU screen, and
thenpress 4/1_ to select "initial Setup",
2 Press A/V to select "lnternet Setup", and then
press ENTER.
3 Press A / V to select "AQUOS Remote Control",
and then press ENTER.
[] AQUOS Remote Control
Set this when operating the IM from equipment
connected by I..AN or wireless [..AN,
When "AQUOS Remote Control" is selected,
"Change" will be highlighted, Press ENTER.
Enable: Allows operation from the connected
equipment.
Disable: This function does not work,
[] Select Device Names
Set the name of the TV displayed on the
porlable device,
Use the software keyboard to set the name, See
page 54 for details on the software keyboard,
[] Detailed Settings
Make the detailed settings (Login ID, password,
etc.). Follow the on-screen instructions to
confi gure the settings,
When you use this function, make settings for "
AQUOS Remote Control",
The connection win be cut off when there has
been no communication for 3 minutes,
Set the RS--232C communication settings on been no
match the ]M's communication conditions, The TM's
communication settings are as follows:
9,600 bps
8 bits
None
1 bit
None
[] Communication procedure
Send the control commands from the PC via the
RS--232C or IP, The IM operates according to the
received command and sends a response message
to the PC,Do not send multiple commands at the
same time, Wait until the PC receives the OK response
bdore sending the next command,
See RS--232C Port Specifications for Command
format,
O- 53
To Next Page
Loading...
