On=Screen Display Menu
• "DI Film Mode" does not function depending on input signal
type.
"Auto" does not function when channel display shows
an input signal resolution of 480p, 720p, or 1080p.
"DI Film Mode" is not available during PC format input.
Produces a clearer video image,
Auto; Automatically adjusts the level of noise reduction.
Nigh/Medium/Low: Select a desired level for viewing a
clearer video image.
Off: No adjustment.
• "Digital Noise Reduction" is not available when you set
PC format is being input.
You can adjust the sound quality to your preference
with the following settings,
Example
Smart I
USB Cel]tla_
1 Press MENU to display the MENU screen, and then
press _1/1_ to select "Audio Settings".
2 Press A/Y to select a specific adjustment item,
• Select "Surround", and then press ENTER to set each
item.
3 Press A/Y to seWectthe desired sefting, and then
press ENTER.
4 Press MENU to exit.
Treble Forweaker treble
Bass Forweaker bass
Balance Decrease audio
from the right
speaker
Forstronger treble
Forstronger bass
Decrease audio
from the left
speaker
• For resetting Audio adjustment items to the factory preset
values, press A/T to select "Reset", press ENTER, press
A/_' to select "Yes", and then press ENTER.
The surround function produces Surround effect from
the speakers,
On: Makes it possible to enjoy natural, realistic surround
sound.
Off: Outputs the normal sound.
For some discs, setup may be required on your DVD/BD
player, in this case, please refer to the operation manual of
your DVD/BD player.
n ® . _ 0
Power control setting allows you to save energy,
Example
1 Press MENU to display the MENU screen, and then
press 4/_,. to select "Power Control".
2 Press A/T to select a specific adjustment item,
and then press ENTER.
3 Press A/Y to select the desired setting, and then
press ENTER,
4 Press MENU to exit,
This function allows the TV to automatically shut the
power down when there is no signal received,
Enable: The power will automatically shut down if there is
no signal for 15 minutes.
Disable: This function does not work.
When it is 5 seconds before the power shuts down,the
screen will display"No signal. The power will be turned off."
This function allows you to set the Power Saving level
in order to decrease the power consumption and
increase the backlight lifespan,
On: Optimizes power reduction based upon video
content.
Off: This function does not work.
"Power Saving" does not function when you set AV MODE
to "DYNAMIC (Fixed)".
Q- 26
To Next Page
Loading...
