8
Preparation
4
6
Attaching the clamp and bundling the cables with the clamp
Closing the terminal cover
Cables come out from
the small opening.
Fasten the cables with
the holder.
* If routing the cables on
the right side, use the
holder on the right.
Fit the band around system cables.
1 Pass the end of the
band through the
hole.
2 Pull the band
toward you and
fasten to the tab.
5
Cable clamp
Insert the cable clamp in the hole on the Display as shown.
Fix the system cables firmly to the Display as shown.
* If routing the cables on the right side, use the holder on the right.
LC-65GD1E(E)-a 05.9.21, 7:20 AM8
To Next Page
Loading...
