Sharp Aquos LC-65GD1E

10
Removing the stand
Before detaching (or attaching) stand, unplug the AC cord from the AC input terminal and the system cable
from the Display.
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the System.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
Preparation
NOTE
• To attach the stand, perform the above steps in reverse order.
2
Unfasten the eight screws
used to secure the stand
in place.
1
Unfasten the four screws
used to secure the bracket
in place.
3
Detach the stand from the
Display. (Hold the stand so
it will not drop from the
edge of the base area.)
4
Attach the stand hole
covers (supplied with the
product).
Removing speakers
NOTE
• To attach the speakers, perform the steps in reverse order.
• Perform the same steps for the left section of the speaker.
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
1
2
3
Unfasten the screws.
Take off the speaker terminal cover.
Disconnect the cable from the speaker.
1
1
2
LC-65GD1E(E)-b 05.9.21, 7:22 AM10