Sharp Aquos LC-65GD1E

20
Watching TV
Simple button operation for changing
volume/sound
Changing the volume
You can change the volume on the Display or on the
remote control unit.
NOTE
• “TV”, “DTV”, “INPUT1”, “INPUT2”, “INPUT3”, “INPUT4”,
“INPUT5” and “CARD” modes can each store volume
adjustment values separately.
Audio status
When “Audio Out” is set to “Variable”, the indicator on
the screen changes as shown below.
Output device
Variable sound
Audio out
VariableFixed
Variable sound
Constant as
specified
Mute
20
Speaker
AV OUTPUT
NOTE
• See page 66 for details on the audio out function.
Using e on the remote control unit
e mutes the current sound output.
Press e.
•“e” has been displayed on the screen for 30
minutes, and the sound is silenced.
Mute
20
NOTE
• Within 30 minutes of pressing e, mute can be cancelled
by using the methods below.
• Pressing i
ee
ee
e/i
ff
ff
f or e can also cancel the mute.
• Mute will be cancelled after 30 minutes have elapsed.
However, the System will not suddenly output a loud
sound as the volume level is set to 0 automatically.
i
kk
kk
k/
ll
ll
l
• To increase the volume, press i
kk
kk
k.
• To decrease the volume, press i
ll
ll
l.
1
2
Within 30 minutes, press e again to cancel
the mute.
• Before 30 minutes, the volume level returns to
the previous setting.
• After 30 minutes, increase the volume level by
pressing ie.
Using SOUND on the remote control unit
Each time you press SOUND, the mode switches as
illustrated in the following tables.
NOTE
• When no signal is input, the sound mode will display
“MONO”.
Selectable items
NICAM STEREO, MONO
NICAM CH A, NICAM CH B, NICAM CH AB,
MONO
NICAM MONO, MONO
Signal
Stereo
Bilingual
Monaural
Selectable items
STEREO, MONO
CH A, CH B, CH AB
MONO
Signal
Stereo
Bilingual
Monaural
NICAM TV broadcasts selection
A2 TV broadcasts selection
LC-65GD1E(E)-c 05.9.21, 7:23 AM20