Sharp AR-162

3. Operation Section
1 INTERRUPT key and indicator 2 Copy quantity display 3 ZOOM indicator
4 Copy ratio display key 5 Zoom keys 6 PAPER SIZE ENTER key
7 AUDIT CLEAR key 8 PAPER SIZE indicators 9 Alarm indicators ∗2
10 POWER SAVE indicator 11 SPF/RSPF indicator 12 Output tray full indicator
13 B/W REVERSE key and indicator 14 XY-ZOOM key and indicator 15 SORT/GROUP key and indicators
16 ORIGINAL DATA indicator 17 2 IN 1 / 4 IN 1 key and indicators 18 AUTO/MANUAL/PHOTO key and
indicators
19 Light and dark keys and indicators ∗3 20 Numeric keys 21 Zero key ∗4
22 CLEAR key 23 START key and indicator 24 CLEAR ALL key
25 PRESET RATIO selector keys and
indicators
26 ORIGINAL SIZE ENTER key and
indicators
27 AUTO PAPER SELECT indicator
28 TRAY SELECT key 29 AUTO IMAGE key and indicator 30 Paper feed location/misfeed location
indicators
31 DUAL PAGE COPY key and indicator 32 ERASE key and indicators 33 MARGIN SHIFT key and indicator
34 ORIGINAL TO COPY key and indicators
∗1
ON: Indicates that the machine is in the energy saving (pre-heat)
mode.
Blink: Indicates that the machine is in the process of resetting from
the energy saving mode or just after supplying the power.
(During warmup)
OFF: Indicates that resetting from the energy saving mode is com-
pleted and that the fusing temperature is in ready state.
The combinations of the above display lamps are as follows:
( = ON, = OFF)
Lamp
Immediately after
power ON
Ready Copying
Pre-heat lamp Blink
Ready lamp
Other lamps
Lamp
Energy
saving mode
(Pre-heating)
Energy
saving mode
(Auto power
shut off)
Resetting
from energy
saving mode
Copy is
started during
resetting from
energy saving
mode
Pre-heat lamp Blink Blink
Ready lamp
Other lamps
∗2
Maintenance indicator
When the set count number (set by the simulation) is reached,
the lamp lights up. The machine does not stop.
Toner cartridge replacement required indicator
When toner density is lower than a specified level, the TONER
CARTRIDGE REPLACEMENT indicator lights up to warn the
user.
If toner is not added after approximately 10% is copied, the
indicator starts blinking and machine starts to supply toner.
(Toner cartridge replacement indicator keeps lighting up)
If toner density is not back to specific level after two minutes, the
READ indicator goes out and Toner indicator starts blinking, and
the copier stops.
Developer replacement required indicator
(1) Lights up when the developer counter reaches 30K.
(2) Selection between STOP and NON-STOP is allowed with the
service simulation No.
(Default: NON-STOP)
Paper required indicator
Misfeed indicator
∗3 Light key
Press and hold this key for 5 sec, and the machine will enter the
user program mode.
∗4 Zero key
Press and hold this key, and the total output counter value is
displayed on the copy quantity display.
Not used for the copier features.
1234567891011121314151617
18 19 20 22 23 24 25 26 27 28 29 30 31 32 343321
AR-162 [4] EXTERNAL VIEWS AND INTERNAL STRUCTURES 11/21/2000
AR-162 EXTERNAL VIEWS AND INTERNAL STRUCTURES – 2