Sharp AR-162 - Optical Frame Unit

Note: When replacing the MCU PWB, be sure to restore the original
jumper conditions.
<Reference: Factory setup>
JP1 JP2 JP3 JP4 JP5 JP6 JP7 JP8
AB
series
AR-162
AR-163 ✕
AR-163
SOPM
✕✕
AR-201 ✕✕ ✕ ✕
AR-F201 ✕✕ ✕✕ ✕
AR-206/207 ✕✕✕✕ ✕✕
Inch
series
AR-162
AR-163 ✕
AR-163
SOPM
✕✕
AR-201 ✕✕✕✕
AR-F201 ✕✕ ✕✕✕
AR-206/207 ✕✕✕✕ ✕ ✕
: Jumper wire provided
✕ : Jumper wire not provided
6. Optical frame unit
No. Content
A Optical frame unit
A. Optical frame unit
Installation: Install the optical unit in the sequence shown above.
7. LSU
No. Content
A LSU unit
A. LSU unit
Note: Do not disassemble the LSU.
Adjustment: • Image lead edge position adjustment
• Image left edge position adjustment
• Paper off-center adjustment
(1)
(1)
(1)
(1)
(2)
(1)
(2)
(3)
(1)
(2)
(1)
(1)
(3)
(4)
(6 )
(5 )
(5 )
AR-162 [11] DISASSEMBLY AND ASSEMBLY 10/5/2000
AR-162 DISASSEMBLY AND ASSEMBLY – 7