Sharp AR-5516

32
COPY FUNCTIONS
Using the SPF/RSPF
1
Place the originals. (p.16)
2
Press the [2 IN 1 / 4 IN 1] key
( / ) to select the mode.
The mode is selected in
the order "2 IN 1"
( ), "4 IN 1" ( ),
"Off".
3
Set the number of copies and other
settings, and press the [START] key ( ).
The copy is delivered to the paper output tray.
If the memory becomes full
• If the memory becomes full while scanning the
originals, the ORIGINAL DATA indicator ( )
will blink, "FUL" will appear in the display, and the
machine will stop copying.
• To copy the originals that have been scanned up
to that point, press the [START] key ( ).
• To clear the data that has been scanned into
memory, press the [CLEAR ALL] key ( ) or the
[CLEAR] key ( ).
Setting the layout pattern
You can select the layout pattern for copying 2 original pages or 4 original pages onto one sheet of paper. The
available layout patterns are shown on the first page of this section.
1
Use the [2 IN 1 / 4 IN 1] key ( / )
to access the setting.
Selecting the layout for 2 IN 1 copy
With the 2 IN 1 / 4 IN 1 indicators off, hold down the [2
IN 1 / 4 IN 1] key ( / ) until the 2 IN 1 indicator
( ) blinks.
The setting code of the
currently selected pattern
will blink in the first digit
of the display.
Selecting the layout for 4 IN 1 copy
With the 2 IN 1 indicator lit ( ), hold down the [2 IN
1 / 4 IN 1] key ( / ) until the 4 IN 1 indicator
( ) blinks.
The setting code of the
currently selected pattern
will blink in the first digit
of the display.
2
Select the setting code by pressing a
numeric key.
To select "Pattern 2",
press the [2] key.
See page 31 for layout pattern.
The factory default settings are indicated by " * ".
The entered number blinks in the first digit of the display.
3
Press the [START] key ( ).
The selected setting code stops blinking and
lights steadily. This completes the setting.
4
Press the [2 IN 1 / 4 IN 1] key
( / ) to exit the setting.
The display returns to the number of copies display.
• To cancel 2 IN 1 / 4 IN 1 copying, press the
[CLEAR] key ().
• To cancel 2 IN 1 / 4 IN 1 copy mode, press
the [2 IN 1 / 4 IN 1] key ( / )
repeatedly until the 2 IN 1 / 4 IN 1 indicators
( / ) are both off.
Note
DATA
The layout pattern can also be selected in the system settings. (p.57)
Note
Function Setting code (p.57)
2 IN 1 layout
* 1 (Pattern 1)
2 (Pattern 2)
4 IN 1 layout
* 1 (Pattern 1)
2 (Pattern 2)
3 (Pattern 3)
4 (Pattern 4)