AR-5618S SIMULATIONS 7-9
26 03 Auditor setting Used to set the auditor.
* When the coin vendor mode is selected, if the auditor setup is ON and the default tray is bypass
tray, the default tray setup must be changed to the 1st tray.
04 Copier duplex setting When this simulation is executed, the current set duplex code number is displayed. Enter the desired
code number of duplex setting and press the [START] key, and the entered code number is set.
* When this simulation is executed, the binding margin setup is automatically set to the default
(left side).
05 Count mode setting When any key input is made, it is displayed on the display section. When the [START] key is pressed,
the set code data are acquired and stored to the count mode set variable and in the EEPROM, and
the machine goes into the sub code input standby mode. However, if the [START] key is pressed
outside the set range, it is not assured. At that time, when the [Interrupt] key is pressed, the data is
not rewritten and the machine goes into the sub code input standby mode. When the [CA] key is
pressed, the simulation is terminated without rewriting the data.
06 Destination setting When this simulation is executed, the current set destination code number is displayed. Enter the
desired code number of the destination and press the [START] key to set the destination.
If this setting is changed, SIM46-19 setting is also changed accordingly.
(The paper size is also changed: AB series is changed to A4, and Inch series to Letter.
The AUTO exposure limit setup is set to the default.
When the destination is changed (from Japan to EX Japan or from EX Japan to Japan),
the maintenance cycle is also set to the default accordingly.)
07 Machine condition check (CPM) When this simulation is executed, the current setting of the machine is displayed.
Main
code
Sub
code
Contents Details of operation
To Next Page
Loading...
