AR-5618S SIMULATIONS 7-10
26 18 Toner save mode setting Used to set ON/OFF of the toner save mode.
* The toner save mode of the user program is also changed accordingly.
The default value depends on the destination.
30 CE mark conformity control ON/
OFF
When this simulation is executed, the current set code number of CE mark conformity is displayed.
Enter the desired code number of CE mark conformity and press the [START] key to set the code
number.
31 Auditor mode exclusive setup Used to set whether the bypass tray can be used or not when the auditor mode is set to the coin
vendor mode.
* When this is set to "Exclusive setup ON," if the auditor is set to the coin vendor mode and the
default tray is set to the bypass tray, the default tray must be reset to the 1st tray.
36 Cancel of stop at maintenance life
over
Used to set stop at maintenance life over.
37 Cancel of stop at developer life
over
When this simulation is executed, the current set code number is displayed. Enter the desired code
number and press the [START] key to set the code number. The machine goes into the sub code
input state.
38 Cancel of stop at drum life over When this simulation is executed, the current set code number is displayed. Enter the desired code
number and press the [START] key to set the code number.
39 Memory capacity check When this simulation is executed, the current memory capacity is displayed.
42 Transfer ON/OFF timing control
setting
When this simulation is executed, the current setting value of transfer ON timing is displayed.
Enter a set value and press the [START] key to set the entered value, and the machine will go into
the sub code input standby mode.
When the [AUTO/TEXT/PHOTO] key is pressed, the ON timing setting and the OFF timing setting
are alternatively selected. At that time, the setting is saved and written into the EEPROM.
•Setting range: 1 ~ 99
When the setting value is increased by 1, time is increased by 2ms.
•The default, 38, of transfer ON timing means "320ms passed from PS release."
The default, 50, of transfer OFF timing means "304ms passed from P-IN OFF."
Main
code
Sub
code
Contents Details of operation
To Next Page
Loading...
