103
✂
KEY OPERATOR CODE NUMBER:
FACTORY SETTING
The following is the factory setting of the Key Operator Code Number, which must be used to access the Key
Operator Program.
Factory setting = 00000
This number must be entered when accessing the Key Operator Program for the first time. (Page 76)
• The Key Operator Code Number is an important security number allowing the Key Operator to
configure the copier's functions and auditor's settings.
• You should register your own code number – different from the factory setting above – immediately
after your copier is installed.
• Detach this page and store it in a safe place.
Note
Pegasus-E_Copy_Ex.book 103 ページ ２００４年９月２３日 木曜日 午前１１時４１分
To Next Page
Loading...
