Sharp AR-M161 - Two-Sided Copies Using the Bypass Tray

61
4
TWO-SIDED COPIES USING THE
BYPASS TRAY
Follow the steps below to perform two-sided copying manually.
Example: Copying original A and original B onto both sides of the paper
1
Copy original A.
2
Place original B as shown below.
Vertically-oriented
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
Place in the opposite
orientation (rotated 180
degrees) to that of
original A.
3
Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Insert the paper all the
way in.
4
Select the bypass tray with the
[PAPER SELECT] key and then press
the [START] key ( ).
The copies are delivered to the centre tray.
12
1
If you are using the AR-M165/AR-M206/AR-M207
The AR-M165/AR-M206/AR-M207 is equipped
standard with an automatic two-sided copying
function that automatically turns over the paper. If
paper in "Paper that can be used for automatic
2-sided printing" on page 18 is used, this enables
easier two-sided copying than using the bypass tray.
See "TWO-SIDED COPYING" on page 56.
1
1
Original A
Copy of
original A
1
1
Original A
Copy of
original A
2
Original B
2
Original B
• Copies made on the back side of paper
should always be made one sheet at a
time using the bypass tray.
• Straighten curled or wavy paper before
using it. Curled paper may cause
misfeeds, creases, or a poor-quality
image.
2
1
1
Copy of
original A
Original B
2
1
1
Copy of
original A
Original B
Note
Pegasus-E_Copy_Ex.book 61 ページ ２００４年９月２３日 木曜日 午前１１時４１分