Sharp AR-M161

78
USING THE KEY OPERATOR PROGRAMS
1
Press the [SPECIAL FUNCTION] key.
The special function
screen will appear.
2
Select "KEY OPERATOR PRG." with
the [ ] or [ ] key.
3
Press the [OK] key.
The key operator code entry screen appears.
4
Enter the key operator code with the
numeric keys.
• " " appears for each digit that you enter.
• The mode selection screen appears.
5
Select the desired mode with the [ ]
or [ ] key.
Example: The screen when "COPIER" is selected.
6
Press the [OK] key.
The settings of the
selected mode appear.
Several programs will have checkboxes in front of
them. To enable a function (make a checkmark
appear), press the [OK] key. To disable the function,
press the [OK] once again to remove the checkmark.
To configure a program that has a checkbox, go to
step 9.
7
Select the desired program with the
[ ] or [ ] key.
8
Press the [OK] key and follow the
instructions in the program screen.
9
To use another program for the same
mode, select the desired program with
the [ ] or [ ] key.
To use a program for a different mode, press the
[BACK] key and select the desired mode. To exit
the key operator programs, press the [CA] key.
2-SIDED
COPY
SPECIAL FUNCTION
ACC.
DUPLEX SCAN
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
SPECIAL FUNCTION
PAPER SIZE SET
DISPLAY CONTRAST
TOTAL COUNT
KEY OPERATOR PRG.
GHI
OK BACK
Enter key operator
code.
KEY OPERATOR CODE:
-----
ABC DEF
JKLGHI MNO
TUVPQRS WXYZ
@.-
_
FUNCTION
ACC. #-C READ-END
OK
MODE SELECT
KEY OP. # CHANGE
COPIER
PRINTER
SCANNER
MODE SELECT
KEY OP. # CHANGE
COPIER
PRINTER
SCANNER
OK
COPIER
EXPOSURE ADJUST
MARGIN DEFAULT
ERASE ADJUST
CARD SHOT
OK
Pegasus-E_Copy_Ex.book 78 ページ ２００４年９月２３日 木曜日 午前１１時４１分