Sharp AR-M161 - Programming a Key Operator Code

76
PROGRAMMING A KEY OPERATOR
CODE
1
Press the [SPECIAL FUNCTION] key.
The special function
screen will appear.
2
Select "KEY OPERATOR PRG." with
the [ ] or [ ] key.
3
Press the [OK] key.
The key operator code
entry screen appears.
4
Use the numeric keys to enter the
five-digit key operator code.
• If this is the first time you are programming the key
operator code, enter the factory default code. (Page
103)
• " " appears for each digit that you enter.
• The special modes screen will appear with "KEY OP.
# CHANGE" selected.
5
Press the [OK] key.
The key operator code
change screen appears.
6
Enter the new 5-digit key operator
code with the numeric keys.
Any 5 digits can be used for the key operator code.
7
Press the [OK] key.
• The previously programmed
key operation code is
replaced by the new key
operator code.
• Press the [CA] key to return to
the base screen.
2-SIDED
COPY
SPECIAL FUNCTION
ACC.
DUPLEX SCAN
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
SPECIAL FUNCTION
PAPER SIZE SET
DISPLAY CONTRAST
TOTAL COUNT
KEY OPERATOR PRG.
GHI
OK BACK
Enter key operator
code.
KEY OPERATOR CODE:
-----
ABC DEF
JKLGHI MNO
TUVPQRS WXYZ
@.-
_
FUNCTION
ACC. #-C READ-END
OK
MODE SELECT
KEY OP. # CHANGE
COPIER
PRINTER
SCANNER
OK
KEY OP. # CHANGE
PRESENT:22222
NEW :-----
WXYZ
KEY OP. # CHANGE
PRESENT:22222
NEW :111--
OK
Pegasus-E_Copy_Ex.book 76 ページ ２００４年９月２３日 木曜日 午前１１時４１分