Sharp AR-M276

AR-M236/M276/M237/M277 SIMULATION 8 - 21
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Operation/procedure
1. Select the counter to be cleared with the 10-key.
2. Press the [START] key.
The confirmation menu is shown.
3. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Operation/procedure
1. Select the "3: NUMBER OF PRINTS", and press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
Note: Executable only when the FAX is installed.
Operation/procedure
1. Press the [START] key.
The confirmation menu is shown.
2. Select "1: YES."
1: YES (Cleared)
2: NO (Not cleared) (Default)
The scanner mode counter and the number of send of the scanner are
cleared.
* The simulation to perform communication with the PCL is inhibited
until Notice Page storing is completed. (Only when the serviceman
call error occurs.)
* When in other than the serviceman call error, entering the simulation
is not allowed from the system check display.
24-6
Purpose Data clear
Function (Purpose) Used to clear the copy counter.
Item Counter Copier
24-7
Purpose Data clear
Function
(Purpose)
Used to clear the OPC drum (membrane decrease)
correction counter. (This simulation is executed when
the OPC drum is replaced.
Section Image process (Photoconductor/Developing/Transfer/
Cleaning)
Photo conductor
Item Counter
24-9
Purpose Data clear
Function
(Purpose)
Used to clear the printer counter and other counters.
(The counter is cleared after completion of
maintenance.)
Section Printer
Item Counter Printer
Item Content
1 PRINTER Printer counter
2IMC IMC counter
3DUPLEX DUPLEX counter
4OTHERS The other counters
24-10
Purpose Data clear
Function (Purpose) FAX counter data clear
Section FAX
Item Counter
Item Content
1 FAX SEND
(PAGE & TIME)
FAX send page and time
2 FAX RECEIVE
(PAGE & TIME)
FAX receive page and time
3 FAX OUTPUT FAX output (number of prints)
24-15
Purpose Data clear
Function
(Purpose)
Used to clear the scanner counter in the network
scanner mode.
Section Scanner section
Item Counter
25
25-1
Purpose Operation test/check
Function
(Purpose)
Used to check the operation of the main drive
(excluding the scanner section) and to check the
operation of the toner concentration sensor. (The toner
concentration sensor output can be monitored.) (To be
supported for Ver.00.72 or later)
Section DRIVE
Item Operation