Sharp AR-M276

AR-M236/M276/M237/M277 SIMULATION 8 - 26
Operation/procedure
Enter the set value with the 10-key, and press the [START] key.
Operation/procedure
When this setting is made, the image output direction in the staple
mode and that in the normal mode become the same. Therefore, the
user who uses printed paper (logo, house style, etc) need not change
the original direction in the staple mode. (When the finisher is used,
images are rotated 180 degrees in the staple mode.)
Enter the set value with the 10-key, and press the [START] key.
Note: Executable only when the finisher is installed.
Operation/procedure
Enter the set value with the 10-key, and press the [START] key.
Operation/procedure
Input the set value with the 10-key and press the [START] key.
Operation/procedure
Input the set value with the 10-key and press the [START] key.
This setup varies in connection with SIM 26-6 (Destination setup).
26-41
Purpose Setting
Function
(Purpose)
Used to set ON/OFF of the automatic magnification
ratio selection (AMS) when setting the binding
function.
Item Operation
Item Content Default
0OFF AMS is not set automatically. 0
1ON AMS is set automatically.
26-46
Purpose Setting
Function
(Purpose)
Used to set whether to meet with the output direction of
images regardless of the mode when installing the
finisher.
Item Operation
Item Content Default
0
OFF No setting (The output image direction is
changed in the staple mode of the finisher.)
0
1
ON Setting (The output image direction is the
same regardless of stapling or not.)
26-50
Purpose Setting
Function
(Purpose)
Used to set ON/OFF of the black and white reversion
function.
Item Operation
Item Content Default
0ON Enable 0
1OFF Disable
26-57
Purpose Setting
Function (Purpose) Used to set the model code.
Item Operation
Item Default
1 AR-M236 1
2 AR-M276
3 AR-M237
4 AR-M277
5 AR-266S
6 AR-266G
7 AR-266FG
8 AR-266FP
26-60
Purpose Setting
Function
(Purpose)
Used to set enable/disable of the FAX mode key when
FAX is not installed. (When FAX is installed, the FAX
mode is enabled regardless of this setup.)
Item Operation
Item Content
Default
JAPAN,
SEC, SECL,
SUK, SCA
Others
0 ON Effective (The message with
FAX uninstalled is displayed.)
01
1 OFF Disable (Error Beep)
26-71
Purpose Setting
Function
(Purpose)
In the power save time setting, the pre-heat (pre-heat
mode setting) and the auto power shut off time can be
set to the short time setup (pre-heat: 1 min, auto power
shut off: 4 min) and the long time setup (pre-heat:
15min, auto power shut off: 60min).