20
Listening to the Radio
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3 Press the TUNING/TIME (
XX
XX
X or
WW
WW
W) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button as many times as required to tune in to the
desired station.
Auto tuning:
When the TUNING/TIME
button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
Notes:
● When radio interference occurs, auto scan tuning may stop automatically at
that point.
●
Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING/TIME
button again.
FM stereo mode indicator
FM stereo receiving indicator
Radio
– Listening to the Radio –
To receive an FM stereo transmission:
Press the TUNER (BAND) button so that the “ST” indicator lights up.
● “j” will appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER (BAND) button so that the “ST” indi-
cator goes out. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
■ Sound Control (See page 14)
*BA300_P20_21 00.11.16, 2:51 PM20
To Next Page
Loading...
