Sharp CD-BA300 - Listening to the Memorized Station

21
■
Memorizing a station
You can store 40 AM and FM stations in memory and recall them at the push of a
button. (Preset tuning)
1 Perform the steps 1 - 3 in “Listening to the Radio” on page 20.
2 Press the MEMORY/SET button to enter the preset tuning saving
mode.
3 Within 30 seconds, press the
55
55
5
33
33
3 PRESET
XX
XX
X or
WW
WW
W PRESET
22
22
2
44
44
4 button to select the preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY/SET button to store that
station in memory.
If the “MEMORY” and preset number indicators go out before the station is
memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a preset
station.
When a new station is stored in memory, the station previously memorized will
be erased.
■
To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
1 Press the
55
55
5
33
33
3 PRESET
XX
XX
X or
WW
WW
W PRESET
22
22
2
44
44
4 button for
more than 0.5 seconds.
● The preset number will flash and the programmed stations will be tuned in
sequentially, for 5 seconds each.
● This can be operated by pressing the PRESET (X or W) button on the
remote control.
2 Press the
55
55
5
33
33
3 PRESET
XX
XX
X or
WW
WW
W PRESET
22
22
2
44
44
4 button again
when the desired station is located.
■
To recall a memorized station
Press the
55
55
5
33
33
3 PRESET
XX
XX
X or
WW
WW
W PRESET
22
22
2
44
44
4 button for less
than 0.5 seconds to select the desired station.
This can be operated by pressing the PRESET (X or W) button on the remote control.
Note:
The backup function protects the memorized stations for a few hours should there be
a power failure or the AC power cord disconnection.
Preset channel Frequency and frequency band
Radio
– Listening to the memorized station –
Listening to the memorized station
■
To erase entire preset memory
1. Press the ON/STAND-BY button to enter the stand-by mode.
2. Press the ON/STAND-BY button while holding down the TUNER (BAND) button
and X-BASS/DEMO button until “TUNER CL” appears.
■ Listening to the Radio (See page 20)
*BA300_P20_21 00.11.16, 2:51 PM21