(Continued)
PRESET
TUNER
(BAND)
TUNER
(BAND)
MEMORY
Jog dial
■ Preset tuning
You can store up to 40 stations in memory (40 stations con-
sisting of any combination of FM, MW and LW stations you
like) and recall them at the push of a button.
To enter stations into memory:
1 Perform steps 1 - 6 of the "Tuning" section.
2 Press the MEMORY button.
3 Within 30 seconds, turn the jog dial until the preset chan-
nel number flashes in the display.
● Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY button to store
that station in the selected station preset number memory.
● If the "MEMORY" and preset number indicators go out
before the station is memorised, repeat the operation from
step 2.
5 Repeat steps 1 - 4 to set other preset stations, or to
change a preset station.
To recall a memorised station:
Turn the jog dial on the main unit or press the PRESET (
X
or
W
) button on the remote control for less than 0.5 seconds
to select the desired station.
● The contents (preset channel number, frequency and fre-
quency band) which have been stored in memory will ap-
pear in the display in numerical order, irrespective of the
frequency bands.
Note:
When searching for a memorised station, do not press the
PRESET button for more than 0.5 seconds.
When the PRESET button is pressed for more than 0.5 sec-
onds, the unit will enter the preset memory scan mode.
Backup function:
The backup function protects all station presets for a few
hours should there be a power failure or the AC power lead
is removed from the AC socket.
■ Preset memory scan
The stations saved in the preset memory can be scanned
automatically.
1 To scan the preset stations, press the PRESET (
X
or
W
) button for more than 0.5 seconds.
● The station preset number flashes and programmed sta-
tions are sequentially received for 5 seconds each.
2 Press the PRESET (
X
or
W
) button again to stop the
memory scan at the desired station.
Note:
When the preset memory does not have any stations stored
in it, the preset memory scan will not function.
PRESET
(Remote control operation)
CD-C491H(SUK) TINSE0229AWZZ
18
To Next Page
Loading...
Need help?
General
