Sharp CD-C491H

(Continued)
PTY.TI
SEARCH
Jog dial
EON
1
2
3
4
5
■ EON-TI
1 Tune in the desired RDS station, then the PS name will
be displayed.
2 Press the EON button when "EON" appears.
● "PTY.TI" and "SELECT" will appear alternately for about
4 seconds.
3 Whilst they are being displayed, select the TI (Traffic In-
formation) turning the jog dial.
● The selected "TI" will flash.
4 Within 4 seconds, press the PTY.TI SEARCH button.
● "TI" and "WAITING" will appear for 2 seconds each.
● "TI" will appear, and the unit will enter the EON-TI stand-by
mode.
5 When a TA specifed starts on a other network station,
the unit will automatically switch to that station, and "TI"
will flash.
6 When the traffic announcement is over, the unit will au-
tomatically return to the original station you were tuned
to.
Note:
● If the EON button is pressed when "EON" is not displayed,
"NO EON" will appear for 4 seconds to indicate that the
unit cannot enter the EON stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button.
("TI" → "WAITING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button.
Within 4 seconds, press it again. The EON stand-by mode
will be cancelled.
● "TI" will go out.
Note:
● If neither "TP" nor "TA" appear, then even if "EON" ap-
pears the unit cannot enter the EON-TI stand-by mode.
In this condition, even if the EON button is pressed, "NO
TI" will flash for 4 seconds.
Notes:
● During the same programme as the specified PTY (or TA)
is being broadcast on the station you are receiving, the
unit will not switch to other network station.
● If there are more than two other network stations you want
to listen to, compare the strength of each station’s signal
and tune in the station with the strongest signal. (EON-AF)
However, if the frequency of other network station has
been stored in the preset channel memory, the unit will
switch to that preset channel.
● If you want to cancel the reception of an ON (other net-
work) station which was tuned in by the EON system and
return to the original station you were receiving, press the
EON button.
● After the unit returns to the original station, the stand-by
mode will still be active. (The "TI" or "PTY" will remain lit.)
● The unit will not switch from the ON station to another
network station. The unit returns to the original station.
● When the unit switches automatically to "other network"
station, if there is any problem with this station or the
station cannot be received properly, "NO READY" will ap-
pear and the unit will return to the original station.
CD-C491H(SUK) TINSE0229AWZZ
24