RADIO OPERATION
TUNER
(BAND)
TUNING
( )
ON/
STAND-BY
■ Tuning
(Main unit operation)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the desired
frequency band. (FM ST, FM, MW or LW)
4 Press the TUNING (
X
or
W
) button to tune into the de-
sired station.
Manual tuning:
Press the TUNING (
X
or
W
) button as many times as re-
quired to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING (
X
or
W
) button is pressed for more
than 0.5 seconds, scanning will start automatically and the
tuner will stop at the first receivable broadcast station.
Notes:
● When radio interference occurs during auto scan tuning,
auto scan tuning may stop automatically at that point.
● If a weak station signal is found during auto scan tuning,
the station will skipped.
● To stop the auto tuning, press the TUNING (X or W) button
again.
● When an RDS (Radio Data System) station is tuned in,
the RDS indicator will light first, and then the frequency
will be displayed. Finally, the station name will appear.
5 To receive an FM stereo transmission, press the TUNER
(BAND) button so that the "ST" indicator on the display
lights up.
● "
j
" will appear when an FM broadcast is in stereo.
6 If the FM reception is weak, press the TUNER (BAND)
button so that the "ST" indicator goes out.
● Although the reception changes to monaural, the sound
becomes clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Note:
● The last station tuned in will be recalled, even after chang-
ing the tuning band or the function, or after switching the
unit to the stand-by mode.
CD-C491H(SUK) TINSE0229AWZZ
17
To Next Page
Loading...
Need help?
General
