RECORDING
● When recording important selections, be sure to make a
preliminary test to ensure that the desired material is being
properly recorded.
● The ALC (Automatic Record Level Control) circuit auto-
matically controls the level of the input signal used for
recording.
ON/
STAND-BY
TAPE
(1 2)
REVERSE
MODE
CD
NORMAL
TAPE 2
1CD
A
B
2345
1TAPE 2 3
45
● The volume and sound quality may be adjusted without
affecting the signal being recorded at the same time.
(Variable Sound Monitor)
● Metal tape should not be used for recording or dubbing.
■ Recording from the built-in CD player
(CD Synchronised Recording System)
(Main unit operation)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TAPE (1
V
2) button to select TAPE 2.
3 Load a cassette into the TAPE 2 cassette compartment.
● Wind past the tape leader, on which a recording can not
be performed.
4 Press the REVERSE MODE button.
... To record on only one side.
... To record on both sides.
5 Press the CD button and load the desired disc.
● Use the APMS function to store the tracks you want to
record in memory. (See page 16.)
6 Press the NORMAL EDIT button.
● At this point, the HIGH EDIT button will not work.
● CD playback will start approximately 2 seconds after the
side A (1) tape starts.
Note:
● Do not open the disc tray whilst recording the CD.
To stop recording:
Press the ■ button.
● The CD and tape will stop.
Auto restart function:
● When recording continuously on both sides of the
tape:
Even if the last track of side A (1) is not finished recording,
side B (2) will automatically start recording from the beginning
of that track.
The recording will be made without cutting the beginning of
the track on side B (2).
CD-C491H(SUK) TINSE0229AWZZ
26
To Next Page
Loading...
Need help?
General
