CASSETTE OPERATION
TAPE
(1 2)
ON/
STAND-BY
ON/STAND-BY
TAPE 1
TAPE
(1 2)
4
3
ON/
STAND-BY
ON/
STAND-BY
TAPE 2
TAPE
(1 2)
REVERSE
MODE
TAPE
(1 2)
Reverse mode indicator
4
3
■ TAPE 1 playback
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TAPE (1
V
2) button to select TAPE 1.
3 Open the cassette door by pushing the area marked
"PUSH EJECT".
4 Load a cassette into the TAPE 1 cassette compartment.
5 Press the
0
/
R
(
0
) button to start playback.
To stop playback:
Press the ■ (TAPE ■) button.
■ TAPE 2 playback
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TAPE (1
V
2) button to select TAPE 2.
3 Open the cassette door by pushing the area marked
"PUSH EJECT".
4 Load a cassette into the TAPE 2 cassette compartment.
5 Press the REVERSE MODE button.
... To listen to one side of the tape.
... To listen to both sides of the tape.
... For endless repeat play of both sides of the tape.
( )
( )
( )
6 Press the
0
/
R
(
0
) button to listen to side A (1), or
the
1
button for side B (2).
● To play both sides of the tape ( ), start from side A
(1). When the tape starts playback from side B (2), side
A (1) will not be played after side B (2) finishes.
To stop playback:
Press the ■ (TAPE ■) button.
Fast forward/rewind:
➀ Press the ■ (TAPE ■) button, then the TAPE (1
V
2) button
to select TAPE 2.
➁ To advance the tape, press the
2
button. To rewind it,
press the
3
button.
Caution:
● To remove the cassette tape, press the ■ (TAPE ■) but-
ton, and then open the cassette compartment.
● Before changing from one tape operation to another, press
the ■ (TAPE ■) button.
● If a power failure occurs during tape operation, the tape
head will remain engaged with the tape and the cassette
door will not open. In this case, wait until the power is
restored.
CD-C491H(SUK) TINSE0229AWZZ
25
To Next Page
Loading...
Need help?
General
