ENGLISH
24
CD-DVD500H
Setting the digital out
DIGITAL: Use these settings for specifying the type of digital output when play-
ing a disc recorded using Dolby Digital.
When playing a disc recorded using Dolby Digital (5.1ch), you can specify either
“BITSTREAM” or “D-PCM” as the digital type output.
1 Whilst a disc is stopped, press the SET UP button whilst pressing down the
SHIFT button to display the setup screen.
2 Use the or button to select the “ AUDIO SETUP”.
3 Press the ENTER button and then use the or button to select “ DIGI-
TAL”.
4 Press the ENTER button to display the set-
tings you can select.
5 Use the or button to select “BITSTREAM” or “D-PCM”.
BITSTREAM: Use this setting for a digital connection of a receiver (amplifier)
equipped with a Dolby Digital decoder.
D-PCM: Use this setting for a digital connection to the PCM digital input
socket of a DAT or MD, or for a digital connection to a receiver
(amplifier) that does not have a Dolby Digital decoder.
6 Press the ENTER button to confirm the setting.
To exit the setup screen and return to the startup screen, press the SET UP button
whilst pressing down the SHIFT button or the RETURN button.
Note:
If a disc recorded using Dolby Digital (5.1 channel) is played back with “D-PCM” set-
ting, this unit enters the Dolby Pro Logic surround mode.
To play the disc in the Dolby Digital mode, use “BITSTREAM”. (Refer to page 47 for details.)
(Down Mix PCM)
Audio setting
COMPRESS I ON: OFF
DEUTSCH
ITALIANO
LANGUAGE: ENGL
IUD O ESTUPA
D
MPEG :
IGITAL:
BITSTREAM
BITSTREAM
D · PCM
DVD setting
– Audio setting –
Setting the MPEG audio
1 Whilst a disc is stopped, press the SET UP button whilst pressing down the
SHIFT button to display the setup screen.
2 Use the or button to select the “ AUDIO SETUP”.
3 Press the ENTER button and then use the or button to select “MPEG”.
4 Press the ENTER button to display the settings
you can select.
5 Use the or button to select “BITSTREAM” or “PCM”.
BITSTREAM: Use this setting for a digital connection of a receiver (amplifier)
equipped with an MPEG audio decoder.
PCM: Use this setting for a digital connection to the PCM digital input
socket of a DAT or MD, or for a digital connection to a receiver
(amplifier) that does not have an MPEG audio decoder.
6 Press the ENTER button to confirm the setting.
To exit the setup screen and return to the startup screen, press the SET UP button
whilst pressing down the SHIFT button or the RETURN button.
Note:
If the unit is set to “BITSTREAM”, NO SOUND WILL BE HEARD. To play back the
sound with this unit, set it to “PCM”.
D
COMPRESS I ON: OFF
DEUTSCH
ITALIANO
ESPAÑOL
LANGUAGE: ENGL
IUD O ESTUPA
D
MPEG :
IGITAL:
BITSTREAM
BITSTREAM
BITSTREAM
PCM
To Next Page
Loading...
