Sharp CD-DVD500H - Recording from a DVD (Dvds)

63
CD-DVD500H
ENGLISH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Tape recording
– Recording from a DVD (DVDs)
–
1 Press the ON/STAND-BY button to turn the power on.
2 Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3 Press the DVD/CD button and load the desired disc.
4 Press one of the
s s
s s
s 1 -
s s
s s
s 3 buttons to select the disc to be re-
corded.
5 Press the
00
00
0 button to start DVD playback.
If the disc you are using supports auto start, it starts to play automatically (even
if you do not press the 0 button), as soon as you close the disc tray.
6 Press the REC PAUSE
I6I6
I6I6
I6 (
I6I6
I6I6
I6) button.
Recording will be paused.
7 When DVD playback reaches the desired point, press the
00
00
0 but-
ton to start recording.
To stop recording:
Press the ■ button.
It will stop the tape only. Another press of the ■ button will stop DVD playback.
Even when the DVD playback is finished, the tape will not stop. To stop the tape,
press the ■ button.
Recording from a DVD (DVDs)
Erase-prevention tab of cassette tapes:
When recording on a cassette tape, make sure
that the erase-prevention tabs are not re-
moved.
Cassettes have removable tabs that prevent
accidental recording or erasing.
To protect the recorded sound, remove the tab
after recording.
Cover the tab hole with adhesive tape to record
on the tape without the tab.
Side A
Tab for side ATab for side B
Before recording:
When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
SHARP is not liable for damage or loss of your recording arising from malfunction of
this unit.
The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
For recording, use only normal tapes. Do not use metal or CrO2 tapes.