Sharp CD-DVD500H - Listening to a Cassette Tape (TAPE 1 or TAPE 2)

ENGLISH
62
CD-DVD500H
Listening to a cassette tape (TAPE 1 or TAPE 2)
1 Press the ON/STAND-BY button to turn the power on.
2 Open the cassette door by pushing the area marked “
7 7
7 7
7 PUSH
EJECT”.
3 Load the cassette into the TAPE 1 or TAPE
2 cassette compartment with the side to be
played facing towards you.
4 Press the TAPE (1
VV
VV
V 2) button to select the cassette you want to
listen to.
5 Press the
00
00
0 button to start playback.
To stop playback:
Press the ■ button.
Fast forward/rewind: (TAPE 2 only)
1. Press the ■ button, then press the TAPE (1 V 2) button to select TAPE 2.
2. To advance the tape, press the W PRESET 2 4 (2/4) button.
To rewind it, press the 5 3 PRESET X (5/3) button.
Caution:
To remove the cassette, press the ■ button, and then open the compartment.
Before changing from one tape operation to another, press the ■ button.
If a power failure occurs during tape operation, the tape head will remain en-
gaged with the tape and the cassette door will not open. Wait until the power is
restored.
Before playback:
For playback, use normal or low-noise tapes for the best sound.
(Metal or CrO2 tapes are not recommended.)
Do not use C-120 tapes or poor-quality tapes, as they may cause
malfunctions.
Before loading a tape into the cassette compartment, tighten the slack
with a pen or pencil.
TAPE 1 TAPE 2
Playback is possible in TAPE 1 compartment as well as in TAPE 2.
Tape playback
– Listening to a cassette tape (TAPE 1 or TAPE 2) –