11
CD-SW340H
2008/April/18 CD-SW340H_AUS
Preparation for Use
Placing the speaker system
There is no distinction between the right and left speakers.
Note:
The speaker grilles are not removable.
AC power connection
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket. If you plug in the
unit first, the unit will enter the demonstration mode.
Notes:
The unit will start the tape initialisation when plugged in to the wall
socket. During this process, initialising sound will be heard and
the unit cannot be turned on. Wait until the process is finished.
Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
Demonstration mode
External FM aerial
Use an external FM aerial if you require better reception. Consult
your dealer.
Note:
When an external FM aerial is used, disconnect the supplied FM
aerial wire.
Cooling fan:
The main unit is built with a
cooling fan at the rear of the unit
for improved cooling. Please do
not cover the opening of the fan
with any obstacles, as this will
block proper ventilation.
TIMER
CD
4
5
3
2
1
PHONES
RECORD/PLAYBACK
PLAYBACK (PLAY & STOP)
AUDIO
IN
Subwoofer
Left speaker
Main Unit
Right speaker
Floor
Table
Wall socket
(AC 220 - 240 V ~ 50 Hz)
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll and the
subwoofer and front speaker will light up
in flashing mode.
To cancel the demonstration mode:
When the unit is in the power
stand-by mode (demonstration
mode), press the X-BASS
(SURROUND)/DEMO button. The
unit will enter the low power
consumption mode and the
subwoofer and front speaker light
up will be off.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the
X-BASS (SURROUND)/DEMO button again.
Note:
When the power is on, the X-BASS (SURROUND)/DEMO button can
be used to select the extra bass mode.
ANTENNA
FM
75 OHMS
AM
GND
75 ohms
coaxial cable
External FM
aerial