Sharp ER-A410 - Type of Unit Price Entry, Delete Method, Tare Table No. and Scale Entry (#2210, 2231)

97
Type of unit price entry, delete method, tare table no. and scale entry
For each PLU/UPC
For a range of PLUs
* Item: Selection: Entry:
A Delete method (for only UPC) Inhibit to delete in non-accessed 1
(for PLU: fixed 1)
UPC deleting job (#105 in Z1 mode)
Delete in non-accessed UPC 0
deleting job (#105 in Z1 mode)
B Tare table number 1 thru 9
C Scale entry Inhibit 0
Enable 1
Compulsory 2
D Type of unit price entry Prohibit mode 0
Open price only (for only PLU) 1
Preset price only 2
Open price and preset price (for only PLU) 3
Delete mode 4
To program BCD=003 for PLU1
For each PLU/UPC
Programming the PLU 11 thru 20 for “Open and preset price”
For a range
of PLUs
2231
.@
11
@
20
@
003
t
Ç
PrintKey operation
A thru D
2210
.@
1
@
003
t
Ç
PrintKey operation
Example
2231
.
@
@@
t
Ç
End PLU code
(max. 5 digits)
*ABCD
To apply the current
setting of start PLU code
to PLUs within the range
Start PLU code
(max. 5 digits)
Procedure
Direct22312210
PGM 2
2210
.
@ @t
Ç
PLU code
(max. 5 digits)
*ABCD
To program any PLU/UPC
To program zero
To program for the following PLU/UPC
Ä
UPC code
(6 to 13 digits)
ER-A410/A420(SEC)-3 03.12.22 0:18 PM Page 97