REMOTE OPERATIONS
5
When you have finished listening to your
messages, you can do any of the follow-
ing:
~
. Erase all messages:To erase all of
the messages in the box, press “3”.
“3”, and “#”.
. Repeat playback:To listen to your
messages aga]n, press ‘7” ana ‘#“.
● Perform other operations:You can
enter any of the commands descrlbea
in the followlng secllon. ‘other remote
operations”.
● Hang up: If you do not erase !/our
messages first. they will be savea anc
any new messageswill be recordedai-
ter them. In order to make the FO-~55
release the Iine immediatelvprior to
hanging up (necessarypafl]cularly aur-
lng the transfer function), press “+”
twice before hang[ngup.
C
. Whena remote command ISaccepted by the machine, you WIIIhear one beep. If
an incorrect command ISentered, you will hear four beeps. In the !atter case.
re-enter the correct command.
● When entering a command, do not pause longer than 10seconds between each
digjt. If you do. a 4-beep error signal will be issued and the dlglts entered up !O
thatpoint will be disregarded. In this case. re-enter the command from the
beginning.
. If you make two errors (cause two 4-beep signals to be issued) ‘whileenferlng
your remote code number, the line will be disconnected. Thisprevents
unauthorizedpeople from attempting to guess your remote code number.
* If you pause longer than 60 seconds before entennga command. you WIIIbe
disconnected.
USING THE ANSWERING MACHINE
4-9
To Next Page
Loading...
