O S
Setting 3: 4 RINGS MANUALANSWER
Press “1” (YES) to havethe machine answer a call after 4 rings when it ISin
MANUAL reception mode. Press “2” (NO) to turn the function off.
● Factory setting: “2”
Setting 4: TEL/FAX REMOTE NUMBER (TRANSFER CODE)
This sets the 1-digitnumber for activating fax reception from an extension phone.
Enter any number from “O”to “9”.
● Factorysetting: “5”
Setting 5: REMOTE RECEPTION SELECT
This turns detection of the code for activating fax reception from an extension
phone on or off. Press
“ to turn detection on. or “2” to turn detection off.
. Factorysetting: “1”
Setting 6: TRANSACTION REPORT PRINT SELECT
This sets the condition for printing out Transaction Reports. Enter a number from
“l” to “4” as follows:
“1” (ALWAYS PRINT): Print out after each transmission. reception,or error.
“2” (ERR,~MR/MEM PRINT): Print out after an error, timer operation, or memory
operation.
“3” (SEND ONLY):
Print out only after a transmission.
“4” (NEVER PRINT): Never print out.
. Facto~/setting: “2”
Setting 7: DIAL MODE
This sets the mode of dlalling. Press
“ if you are on a tone dial line, or “2” if you
are on a pulse
d l
. Factory setting: “
Note: For all units installed in New Zealand, select “1” for tone dlalling. Thepulse
setting “2” will not operate correctly and must not be used.
8
O S
To Next Page
Loading...
