PRINTING OUT REPORTS AND L
This report is printed out automatically after an operation IScompleted to allow you
to check the result. Your fax is set at the
f to print out the report only when an
error occurs, or after a timer or memory operation. If desired, you can change the
setting to have It printed out under a variety of other conditions.This ISdone by
changing Option Setting 6 as described In Chapter 8.
+ The report cannot be prlnteciout manually.
Exh
SENDER/ The fax number of the other machine Involvedin the transaction. In the
RECEIVER case of a transmission. the number dialled appears. In the case of a
reception, the programmed ID of the sending machine appears. If this
machine does not have an ID function. the communication mode WIII
appear (for example. “G3”).
PAGES
NOTE
Number of pages transmitted or received
-Transmission/reception was normal.
P.FAIL - A power failure occurred.
JAM - A problem with the fax paper or documentoccurred.
NO PAPER - You ran out of fax paper during reception
COM.E-Oto COM.E-7 -A telephonelineerror preventedthetransaction.
Explanations of the error numbers are given In the following tables.
however, these are primarily for use by sewice engineers. In general.
youwill wantto simplytry the transactionagain.If necessary,checkwith
the other party to make sure their machine is functioning properly.
CANCEL - Transmission was cancelled because the
STOP key was
pressed, no document was in the feeder, or the other machine
requested transmission usinga function which your fax does not have,
PRINTING OUT REPORTS AND LISTS
9-5
To Next Page
Loading...
