C P J
If a document doesn’t feed properly during transmission or copying, or DOCUMENT
JAMMED appears in the display, first try pressing the
S key. If the
documentdoesn’t feed out, open the operation panei (grasp the front edge at the
“ R mark and pull up) and pull it out gently.
1 Open the paper compartment cover
(graspthe finger hold on the right side of
the cover and pull up). and remove the
paper roll.
● Caution! Do not touch the metal strip
Inthe compartment. It may be hot if a
document hasjust been printed.
2
Cut off the wrinkled pafl of the paper.
● If any pieces of paper are stuck Inthe
cutter. removethem with caution.
3
N
Reloadthe paper.
. Jammed fax paper ISoften caused by
Improper loading. Be sure to carefully
follow the Instructionsfor paper load-
ing given In “Loading the Fax Paper”
In Chapter 1.
are finding it difficult to reload the recordingpaper, the cutter may still
be engaged In the cutting position Make sure that nopieces of recordingpa-
per are stuck In the cutter assemb/y.ciose the operationpanel, press the
START~EMORY and re-open /1,This wi//reset the cutter assembly, a/-
Iow\ngyou to reload the recording paper.
11-6 TROUBLESHOOTING
To Next Page
Loading...
