ENGLISH
INSERTING BATTERIES IN THE REMOTE CONTROL
1
Remove the Back Cover
Press and slide the back cover to re-
move.
2
Insert batteries
Insert batteries with and as
shown below.
3
Close the Back Cover
REMOTE CONTROL USE
• Operate with the Remote Control facing the Main
unit (Receiver).
• The signal range is about 7m (front).
• Make sure there are no objects blocking the path
of the signal.
•A beep sound will be heard from the Main unit
when a signal is received.
NOTE
•Avoid dropping or damaging on the Remote Con-
trol. In addition, be sure the Remote Control
avoids moisture or place in direct sunlight or near
an electric heater, etc., otherwise a malfunction
may occur.
E-13
Battery Information
• The battery life is about 1 year.
• Replace the batteries when the Remote Control becomes inoperative.
• Incorrect usage of the batteries may cause battery fluid leakage and/or
damage. Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of
the same type. (Use 2 R6(AA) manganese batteries.)
• When not using the unit or Remote Control for an extended period,
remove the batteries. (This prevents malfunction of the Remote Con-
trol from battery fluid leakage.)
*The batteries of the accessory are for initial use only and may be de-
pleted within 1 year.
Receiver
Transmitter
To Next Page
Loading...
