EN-17
NOTE
How to Clean Hard-to-Remove Dirt.
Sensor Filter (Sensitive Dust Sensor)
1. Remove the Sensor
Cover.
Sensor Cover
2. Remove the Sensor
Filter.
If the Sensor Filter
is very dirty, wash it
with water and dry it
thoroughly.
Sensor Filter
3. Install the Sensor
Cover in the Main
Body.
NOTE
How to Clean Hard-to-Remove Dirt.
1. Add a small amount of
mild kitchen detergent to
water and soak for about
10 minutes.
2. Rinse off the mild kitchen
detergent with clean
water.
3. Completely dry the filters
in a well-ventilated area.
Pre-Filters
SIDE PANELS /
PRE-FILTERS
Remove the dust gently with a cleaning tool
such as a vacuum cleaner.
Pre-FilterSide Filter
NOTE
•
Do not apply excessive pressure when
scrubbing the Pre-Filter.
SENSORS
Remove the dust
gently with a cleaning
tool such as a
vacuum cleaner.
Sensors
Filter Name Maintenance Cycle Max Service Life
Replacement Filter
Model
Micro HEPA Plus Filter
Whenever dust accumulates,
when odor emanates from the
air outlet, or once a month.
When the Filter Replacement
Indicator flashes. (About 2
years
*
1, 2
) See Page 18.
FZ-S12H2E
Deodorizing Filter FZ-S70D2E
*1: According to Japan Electrical Manufacturers' Association JEM 1467, the Max service life is based on the equivalent
condition of the smoke from 5 cigarettes per day whereby the dust collection/deodorization power is reduced by half
compared with that of a new filter. It is recommended to replace the filter more frequently under more severe conditions.
*2: Designated App notifies when each replacement part should be replaced according to usage.
Filter life varies depending on the room environment, usage conditions, and location of the product. We
recommend replacing the filter more frequently if the product is used in conditions significantly more
severe (PM2.5 etc.,) than a normal household.
MICRO HEPA PLUS FILTERS / DEODORIZING FILTERS
REPLACEMENT AND MAINTENANCE CYCLE
To Next Page
Loading...
Need help?
General
