EN-3
3. Avoid use in locations where furniture, fabrics,
or other items may come in contact with and
restrict the air inlets and/or outlets.
4. Avoid locations exposed to direct sunlight. It may
cause the product to change shape or color.
5. Avoid locations where the product is exposed to
condensation or drastic changes in temperature.
Use under appropriate conditions between 0ºC –
35ºC.
6. Avoid use in locations where greasy or oily
smoke is generated (such as in a kitchen, etc.).
The Main Body surface may crack and the
sensors may malfunction as a result.
7. The wall directly behind the air outlets and the
floor or rug on which the product is placed may
become dirty over time. When using the product
for an extended period of time at the same
location, periodically clean the walls, the floor or
the rug.
8. Do not place the product near or on hot objects,
such as stoves or heaters, or where it may come
into contact with steam.
CAUTIONS CONCERNING
THE FILTER
1. Follow the instructions in this manual for filter
installation and maintenance
(Page 7, 17).
2. Take out the filters from the plastic bag before
placing the filters in the Main Body.
3. Do not operate the product without the filters
properly installed.
4. Do not wash and reuse the Micro HEPA Plus
Filter and the Deodorizing Filter.
Washing will not improve filter performance
and can also cause electric shock or operating
malfunctions.
5. Do not operate the product in a room where
aerosol insecticides are present. It may cause
the insecticide odor to remain in the product and
be emitted from the air outlets.
CAUTIONS CONCERNING
OPERATION
1. Do not block the air inlets or air outlets.
2. Always operate the product in an upright position.
3. When carrying the product, hold the product by
the handles on both sides.
4. Always lift up the product when moving it on
easily damaged flooring, an uneven surface, or
carpet.
5. Do not use fluororesin or silicone-containing
products (cosmetics, hair care products, etc.,)
near the product. The fluororesin or silicone
could get stuck inside the product, and cause
Plasmacluster Ions cannot be generated.
CAUTIONS CONCERNING
MAINTENANCE
1. Follow the instructions in this manual for
maintenance (Page 16 - 20).
2. Clean the exterior with a soft cloth only.
3. Do not use detergents other than what is
mentioned in this manual (Page 17). Do not
use volatile fluids and/or detergents.
The Main Body surface may be damaged
or cracked with strong corrosive cleansers,
benzine, paint thinner, polishing powder or
grease.
In addition, the sensors may malfunction
as a result if the product has sensors.
4. Do not scrub the Pre-Filter hard during its
maintenance.
5. When replacing filters or any accessories, use
specified parts in this manual.
To Next Page
Loading...
Need help?
General
