04/1/28 CX-GD5100V_EN2.fm
17
GX-CD5100W
CD or MP3 disc Playback
Notes:
● If you press the button during random play, you can move to
the track selected next by the random operation. On the other
hand, the button does not allow you to move to the previous
track. The beginning of the track being played will be located.
● In random play, the unit will select and play tracks automatically.
(You cannot select the order of the tracks.)
Caution:
After performing repeat or random play, be sure to press the ( )
button. Otherwise, the disc will play continuously.
■ Programmed play
You can choose up to 32 selections for playback in the order you like.
To cancel the programmed play mode:
Whilst in the stop mode and the "MEMORY" indicator is lit, press the
CLEAR button on the remote control. The "MEMORY" indicator will
disappear and all the programmed contents will be cleared.
Adding tracks to the programme:
If a programme has been previously stored, the "MEMORY" indicator
will be displayed. Then follow steps 1 - 5 to add tracks. The new
tracks will be stored after the last track of the original programme.
To check which tracks are programmed:
Whilst the unit is stopped in the programmed play mode, press the
or
button.
Notes:
●
When open the CD compartment, the programme is automatically
cancelled.
●
Even if you change the function from CD to another, the pro-
grammed selections will not be cleared.
●
During programme operation, random play is not possible.
1
Whilst in the stop mode, press the
MEMORY button to enter the pro-
gramming save mode.
2
Press the direct search buttons on
the remote control to select
the desired track.
Selected track number
You can also select a track by pressing the
or
button.
3
Press the MEMORY button to save
the track number.
4
Repeat steps 2 - 3 for other tracks. Up to 32 tracks can be
programmed.
If you make a mistake, the programmed tracks can be cleared
by pressing the CLEAR button.
5
Press the ( ) button.
The total number of memory will ap-
pear.
6
Press the / ( / ) button to start playback.
To clear the programmed selections:
Press the CLEAR button on the remote control
whilst the "MEMORY" indicator is flashing.
Each time the button is pressed, one track will
be cleared, beginning with the last track pro-
grammed.
To Next Page
Loading...
Need help?
General
