EasyManua.ls Logo

Sharp GX-CD5100W - Tape Playback; Cassette Tape Playback Guide; Continuous Playback Between Tapes

Sharp GX-CD5100W
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
04/1/28 CX-GD5100V_EN2.fm
20
GX-CD5100W
Tape Playback
Listening to a cassette tape (TAPE 1 or TAPE 2)
Auto power off function:
In the stop mode of tape operation, the main unit enters the stand-
by mode after 15 minutes of inactivity.
Tape 1 playback (one side)
Continuous playback (TAPE 1 to TAPE 2)
To stop playback:
Press the button.
To cancel continuous playback:
Press the CONTINUOUS PLAYBACK button again and " "
indicator will disappear.
Note
:
This function cannot be operated from TAPE 2.
Tape 2 playback (two sides)
To change the side of tape:
Press the or button during playback.
Before playback:
For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not
recommended.)
Do not use C-120 tapes or poor-quality tapes, as
they may cause malfunctions.
Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TAPE (1 2) button to select TAPE 1.
3
Open the cassette compartment by pushing the area
marked " ".
4
Load a cassette into the TAPE 1 cassette compartment
with the side to be played facing towards you.
5
Press the button to start
playback.
Tape play indicator
1
Press the area marked " " and load cassettes into the
TAPE 1 and TAPE 2 cassette compartments.
2
Press the TAPE (1 2) button to select TAPE 1.
3
Press the CONTINUOUS PLAYBACK button.
4
Press the TAPE 1 button to start playback.
Playback begins from side A on TAPE 1, the playback se-
quence will be as follows:
TAPE 1 side A
TAPE 2 side A
TAPE 2 side B
stop
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TAPE (1 2) button to select TAPE 2.
3
Open the cassette compartment by pushing the area
marked " ".
4
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
5
Press the button on the remote control to choose one
side or both sides.
… To listen to both sides.
To play both sides ( ), start from side A. When play-
back starts from side B, side A will not be played.
…For endless repeat play of both sides.
…To listen to one side.
6
Press the button to listen to side A, or the button for side B.
Reverse playForward play

Other manuals for Sharp GX-CD5100W

Related product manuals