Sharp GX-CD5100W - Recording from Built-in Microphone; Mixing Microphone and Tape for Recording; Dubbing Cassette Tapes (Tape 1 to Tape 2)

04/1/28 CX-GD5100V_EN2.fm
23
GX-CD5100W
Tape Recording
■ Recording from the built in microphone
Notes:
● Do not connect anything to the Mixing Mic socket.
● Monitoring of the recording is not possible.
● Recording from the built-in microphone is not in stereo.
■ Mixing recording from microphone and tape
Notes:
● Place the microphone about 10 - 15 cm (4 - 6") away from the
source.
● If the howling occurs, lower the volume or move the microphone
as far as possible from the speaker.
● To record the microphone signals only, load a cassette into the
TAPE 2 cassette compartment, set the FUNCTION to TAPE 2.
Press the button and then press the TAPE 2 button.
Caution:
When not using the microphone, remove the microphone plug from
the Mixing Mic socket.
■ Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
High speed dubbing:
After step 4 of the above operation, press the HI-SPEED DUBBING
button.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
■ Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing towards you.
2 Press the TAPE (1 2) button until "TAPE 1" appears on the
display.
3 Press the button.
4 Press the TAPE 2 button to erase side A, or the button on
the main unit to erase side B.
Note:
Make sure that the TAPE 1 is not in use.
Do not connect anything to the Mixing Mic socket.
1 Press the TAPE (1 2) button until TAPE 2 appears on the
display.
2 Load a cassette into the TAPE 2 cassette compartment.
3 Press the button to choose one side or both sides.
… To record on both sides.
… To record on only one side.
4 Press the button.
Recording will be paused.
5 Press the button again to begin recording on side A or
button for side B.
1 Connect the microphone plug to the Mixing Mic socket.
2 Press the TAPE 1 function.
3 Load a blank tape into the TAPE 2 cassette compartment.
Insert a pre-recorded cassette into the TAPE 1 cassette
compartment.
4 Press the button.
5 Press the button of TAPE 1.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a pre-recorded cassette into the TAPE 1 cassette
compartment. Insert a blank tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3 Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
The reverse mode will be set to
"".
4 Press the button.
Recording will be paused.
5 Press the TAPE 1 button to start dubbing.