04/1/28 CX-GD5100V_EN2.fm
18
GX-CD5100W
Radio
Listening to the radio
Note:
This product can receive FM stereo/FM monaural and SW1/SW2/
MW monaural broadcast. SW1/SW2/MW stereo broadcasts will not
be played in stereo.
■
Tuning
Notes:
●
When radio interference occurs, auto scan tuning may stop
automatically at that point.
●
Auto scan tuning will skip weak signal stations.
●
To stop the auto tuning, press the TUNING button again.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
●
" " will appear when an FM broadcast is in stereo.
●
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the "ST" indicator. The reception changes to monaural,
and the sound becomes clearer.
■
Memorising a station
You can store 40 (FM, SW-1, SW-2 and MW) stations in memory and
recall them at the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead disconnection.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM, SW-1, SW-2 or MW).
3
Press the TUNING ( or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
FM stereo mode indicator
FM stereo receiving indicator
1
Perform steps 1 - 3 in "Tuning" on page 18.
2
Press the MEMORY button to enter the preset tuning sav-
ing mode.
3
Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators disappear be-
fore the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
To Next Page
Loading...
Need help?
General
