Sharp GX-CD5100W User Manual

04/1/28 GX-CD5100V_EN1.fm
9
GX-CD5100W
Preparation for Use
■ Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into a wall socket. If necessary, adjust
the selector to correspond to the AC power voltage used in your
area.
Selector adjustment:
Slide the selector with a screwdriver to the appropriate voltage
number (AC 110 - 127 V or AC 220 - 240 V).
■ AC power connection
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket. If you plug the unit
first, the unit will enter the demonstration mode.
Notes:
● The unit will start the tape initialisation when plugged in to the wall
socket. During this process, initialising sound will be heard and
the unit cannot be turned on. Wait until the process is finished.
● Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
■ Demonstration mode
To the wall socket
110-127/220-240 V
50/60 Hz
AC 220V
- 240V
VOLTAGE
SELECTOR
AC 110V
- 127V
AC 220V
- 240V
VOLTAGE
SELECTOR
AC 110V
- 127V
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power
stand-by mode (demonstration
mode), press the SIMBA MODE/
DEMO button. The demonstration
mode will be cancelled and the
display will disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the SIMBA
MODE/DEMO button again.
Notes:
● When the power is on, the SIMBA MODE/DEMO button can be
used to select the simba mode.
● Demonstration mode will not be displayed when DC adaptor is
connected or when battery is in use.

Sharp GX-CD5100W Specifications

General

Brand	Sharp
Model	GX-CD5100W
Category	Stereo System
Language	English