Sharp HT-CN400DVW

E-35
HTCN400_500DVW_E.fm03/10/29
HT-CN400DVW
ENGLISH
92LCN500W0270
HT-CN500DVW
CD, CD-R and CD-RW Operation
- CD operation -
CD operation
The following playback functions are the same as DVD or VCD opera-
tions.
Page
Playback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
To locate the beginning of a chapter (track) (skip) . . . . . . . . . . . . . . . . . . . . . . 25
Fast forward/Fast reverse (search) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
To play repeatedly (repeat play) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
To play the contents between the specified points repeatedly (A-B repeat) . . 30
To change the audio channel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
To change the display on TV screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
To start playback from the desired point (direct play) . . . . . . . . . . . . . . . . . . . . 34
! To play in the desired order
(programmed play)
You can play back the desired tracks in a specific order.
Maximum of 99 tracks can be programmed.
When playing SVCD or VCD, cancel the P.B.C. (playback control) (see page 34).
To change the programmed contents:
Repeat the above procedures from step 1.
Programmed contents will be cleared when you perform the following
operations:
" Press the or PROG button in the stop mode.
" Switch the input or remove the discs.
" Set to the stand-by mode.
Notes:
MULTI
PRESET
ADJ/VOL
9
8765
4
0
>
10
321
ENTER
SLEEP
ST/MO
TUNING
DISPLAY LANGUAGE
MUTE
PROG
MENU/PBC
NTSC/PAL
STEP
A-B
REPEAT
ANGLE
DIRECT
LISTENING
SLOW/MEMORY
TITLE
ZOOM AUDIO
RETURN
MODE
SUBTITLE
SET UP
OPEN/
CLOSE
ON/
STAND-BY
ECHO
9
8765
4
0
>
10
321
PROG
REPEAT
1
Whilst stopped, press the PROG button.
TV screen Unit display
2
Enter a track number with the direct number buttons.
" Repeat the procedure above to enter other track numbers.
" If you enter the wrong number, press the PROG button and then start over from
step 1.
" If the track number is 2 digits or more, press ">10" and enter the number.
Example:
To select track 14: Press ">10" and "4".
3
Press the / button to start play.
" Programming is not possible whilst paused or during playback.
" Sequential programming does not work if the disc disables programming or does
not have track information.
" During programmed play, repeat play can be performed by pressing the REPEAT
button (see page 29).
A-B REPEAT 1SLEEPCHPPRESET
KHz
MHz
PROG
PROGRAM P00:00
PROG
A-B REPEAT 1SLEEPCHPPRESET
KHz
MHz
PROG
PROGRAM P01:02