The discharged air has odor.
• The Plasmacluster Ion Generator releases a
small trace of ozone which may produce odor.
This is not detrimental to health.
TROUBLESHOOTING
Problem
WHAT TO DO
The Plasmacluster Ion
Generator does not work.
Unit Replacement Light is
fl ashing (red)
Operation Lights "LOW", "HIGH",
and "FULL POWER" (blue) fl ash
slowly at the same time and the
operation is stopped
Filter Clean Light is lighting
(orange)
A discontinuous noise is heard.
A clicking or ticking sound
comes from the unit.
The air fl ow decreases.
• Clicking or ticking sound may be audible when
the unit is generating ions.
• Dust may block the fi lter, clean the fi lter.
(See E-9)
• It reach the usage period of ion generating unit.
Replace with new Plasmacluster Ion Generating
Unit
. (See E-12)
• If the replacement period of the unit is passed,
the Unit Replacement Light (red) fl ashes rapidly
and the operation is stopped. (See E-12)
• Plasmacluster Ions are not released.
• Clean the electrode section of the unit.
(See E-10)
• Is the Plasmacluster Ion Generating Unit
installed correctly? Remove the unit, fully
inserted again and press the Operation Button.
(See E-12)
Failure
Unplug and contact the store you purchased or
SHARP service centre.
• Is a AC Adapter inserted properly?
Insert AC Adapter correctly.
• It takes approx. 2 seconds for power distribution
after the plug is inserted in the outlet.
E-14
Other indication
• If you operate the product at “FULL POWER”,
the AC adapter becomes hot. However, it is not
a failure.
• If it is abnormally hot, stop the operation and
pull out the AC adapter from an outlet and
contact the store you purchased the product or
SHARP service centre.
•
Clean the fi lter. (See E-9)
• Press the Filter Reset Button for 3 seconds or
more to reset. (See E-9)
AC adapter is hot
UNIT
FILTER
CLEAN
fl ashing (red)
lighting (orange)
fl ashing (blue)
IG-DX10A.EN.indd16IG-DX10A.EN.indd16 2011/11/0710:59:532011/11/0710:59:53
To Next Page
Loading...
Need help?
General
