E-6
Precautions on installation
Connecting power supply
INSTALLATION GUIDANCE
Be sure to place the product at the stable place.
• Be sure to place the product on a fl at surface.
• Operating temperature : 0
°C
to 35
°C
• Do not block the air inlet and the air outlet.
• If this Plasmacluster Ion Generator cause interference to radio or television reception,
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the product and radio/TV receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If you use the product for a long time at the same place, the wall, fl oor, or carpet
around the main unit may become dirty.
• It is recommended to move the installation location of the main unit sometimes or
clean up the surroundings or the surface on which the main unit is installed periodi-
cally. (Laying a mat under the unit is effective to prevent the floor from becoming
dirty.)
• Under factory setting, the Auto Restart Function is set to “OFF”.
< Auto Restart Function >
Even if the AC adapter is pulled out or the
breaker trips, or power outage is generated
during the operation, the operation is
restarted in the last operation mode if the
power supply is resumed.
To set
Press the Operation Button for 5 seconds or
more
→ All lights light up for 5 seconds
To cancel
Press the Operation Button for 5 seconds
or more
→ All lights blink 5 times
AC Adapter
IG-DX10A.EN.indd8IG-DX10A.EN.indd8 2011/11/0710:59:492011/11/0710:59:49
To Next Page
Loading...
Need help?
General
