Sharp LC-40LB480U

32
LC-40LB480U Full HD LED 1080p TV
•If you select Cable from the wall or Antenna, your TV
starts scanning for channels and displays a progress
screen. The scan may take several minutes.
16 Press ENTER to close the wizard. If you selected:
• Cable from the wall or Antenna, your TV tunes to the
first channel it found in the scan.
• Cable/Satellite box, press INPUT to open the INPUT
SOURCE list, press
S or T to select the video input (HDMI
or AV) you connected the box to, then press ENTER. Your
TV switches to the input you selected.
Understanding the
basics
Turning your TV on or off
1 Make sure that the power cord is connected to a power
outlet. See “Connecting power” on page 27.
2 Press /INPUT to turn on your TV. The power indicator
turns off.
3 Press /INPUT again to turn off your TV. Your TV enters
standby mode, and the power indicator turns red.
Selecting the video input source
1 Turn on your TV, then press INPUT.
2 Press
S or T to select a video input source, then press
ENTER.
Note
You can press EXIT, or highlight Skip and
press ENTER, to stop the auto channel
search, but you will need to run the auto
channel search again to create a channel
list.
Warning
When your TV is in standby mode, it is still
receiving power. To completely disconnect
power, unplug the power cord.
Note
If your TV does not receive an input signal
for several minutes, it automatically goes
into standby mode.