Watching TV
When you turn on the TV for the first time, it will automatically memorize the broadcasting channels where you live.
Perform the following steps before you press TV POWER on the remote control unit.
Insert the batteries into the remote control unit. (See page 9.)
t=
2.
3.
Connect the antenna cable to the TV. (See page 13.)
Plug in the AC cord to the AC outlet. (See page 8.)
Language setting
Select from among 3 languages: English, French and
Spanish.
Press A/Y to select the desired language
listed on the screen, and then press ENTER.
Language
Antenna setting
Make sure what kind of connection is made with your
TV when selecting "Air" or "Cable".
Press _11/1_to select "Air" or "Cable".
Press ENTER to enter the setting.
Example
Channel search
Channel auto search makes the TV look for all
channels viewable in the set area.
When "Air" is selected in Antenna setting:
Press 4/1_ to select "Start", and then press
ENTER.
OH Search
When "Cable" is selected in Antenna
setting:
Press A/Y to select "Analog & Digital Search
Start" to search both analog and digital
broadcasts or "Analog Search Start" to search
only analog broadcasts, and then press
ENTER.
OH Se_ch
,, The Channel search will start automatically.
., To exit the Channel search screen, select "Cancel"
and then press ENTER.
Example
Air [ 25] Found [ 20] J
1!
., If no channel is found, confirm the type of connection made
with your TV and try EZ Setup again. (See page 23.)
Q- 17
To Next Page
Loading...
Need help?
General